Product ID:QUICK START STARTING FLUID CYLINDER
MSDS Date:06/26/1996
FSC:2910
NIIN:01-444-3434
MSDS Number: CFLHK

QUICK START PRODUCTS LTD

HIGHWAY 251 SOUTH
ROCHELLE, IL 61068
US

Emergency Phone: 815-895-4545815-562-5414(TRANSPO)

Info Phone: 815-895-4545; 815-562-5414

Cage: 78280

QUICK START PRODUCTS LTD

ROCHELLE, IL 61068 US

Telephone: 815-562-5414

Cage: 78280

CARBON DIOXIDE

CAS: 124-38-9

RTECS: FF6400000

OSHA PEL 5000 PPM

ACGIH TLV: 5000PPM/30000STEL;96

ETHYL ETHER (CERCLA)

CAS: 60-29-7

RTECS: KI5775000

OSHA PEL 400 PPM

ACGIH TLV: 400PPM/500STEL; 9596

EPA Report Quantity: 100 LBS

DOT Report Quantity: 100 LBS

N-HEPTANE, RELTAED LIGHT HYDROCARBONS

CAS: 142-82-5

RTECS: MI7700000

OSHA PEL 500 PPM

ACGIH TLV: 400 PPM/500STEL;9596

MINERAL OIL, SEVERELY HYDROTREATED PREDOMINANTLY NAPTHENIC

CAS: 64742-53-6

RTECS: PY8036000

OSHA PEL 5 MG/M3 (OIL MIST)

ACGIH TLV: 5 MG/M3 (OIL MIST)

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALED:DIZZINESS,STRONG
ANESTHESIA,INTOXICATION,UNCONSCIOUSNESS.SKIN:IRRITTATION UPON
PROLONGED CONTACT. DEFATTING OF SKIN.EYE:IRRITITATION.
Explanation of Carcinogenicity:PER MSDS:CARCINOGENICITY:NONE OF
COMPONENTS IN MATL IS LISTED BY IARC/NTP/OSHA OR ACGIH AS
CARCINOGEN.
Effects of Overexposure:DIZZINESS,STRONG
ANESTHESIA,INTOXICATION,UNCONSCIOUSNESS.SKIN IRRITATION, DEFATTING
OF SKIN, EYE IRRITITATION.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHALED:REMOVE TO FRESH AIR.ARTIFICAIL RESPIRATION.CONSULT
PHYSICIAN.SKIN:WASH W/SOAP/WATER.REMOVE SOAKED CLOTHING TO AVOID
PROLONGED SKIN CONTACT.EYE:FLUSH WELL W/RUNNING WATER FOR
15MINS.INGESTED:CA LL PHYSICIAN OR POISON CONTROL CENTER
IMMED.PROPER TREATMENTS DEPENDENT ON CONDITON OF PATIENT AND AMOUNT
INGESTED.

Flash Point Method:TCC
Flash Point:=13.3C, 56.F
>56F,>13C
Autoignition Temp:Autoignition Temp Text:NP
Lower Limits:1.8
Upper Limits:46.0
Extinguishing Media:DRY CHEMICAL,CARBON DIOXIDE,WATER-FOG OR MIST
ONLY,ALCOHOL FOAM.
Fire Fighting Procedures:AVOID POSSIBLE ACCUMULATION OF VAPOUR AT FLOOR
LEVEL AS VAPOUR IS HEAVIER THAN AIR.SCBA/PROTECTIVE CLOTHING SHOULD
BE WORN IN FIGHTING FIRES INVOLVING CHEMICALS.
Unusual Fire/Explosion Hazard:AVOID POSSIBLE BURSTING OF AEROSOL
CAN.DONT STORE WHERE TEMPERATURES MAY EXCEED 120F.DONT
PUNCUTRE/INCINERATE.EXTREMELY FLAMM-REFERENCE:CONSUMER PROD
COMMODITIES FLAME PROJECTION TEST.

Spill Release Procedures:KEEP AWAY FROM
HEAT/FIRE/SPARKS/FLAME.VENTIALTE AREA WELL.CO2 MAY BE USED AS
PRECAUTIONARY VAPOR BLANKET.SMALL AMOUNTS MAY BE FLUSHED AWAY WITH
WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DONT STORE WHERE TEMPERATURES ARE
GREATER THAN120F.STORE AWAY FROM FIRE/SPARK/FLAME.STORE IN SUITABLE
AREA FOR HAZARDOUS MATERIALS STORAGE.DONT USE NEAR
HEAT/FIRE/FLAME/SPARK.
Other Precautions:DO NOT USE NEAR HEAT, FLAME OR SPARKS. AVOID
EXCESSIVE BRETHING OF VAPOR. DO NOT SPRAY IN DIRECTION OF BODY. USE
ONLY INN ACCORDANCE WITH DIRECTIONS.

Respiratory Protection:IF TLV IS EXCEEDED WEAR NIOSH=APPROV
SELF-CONTAINED BREATHING DEVICE OR RESPIRATOR.
Ventilation:MUSE BE ADEQUATE TO MAINTAIN VAPORS AT LESS THAN 400PPM
PARTICULARLY ATLFOOR LEVEL AS VAPORS ARE HEAVIER THAN AIR.
Protective Gloves:NORMAL USE-NONE.PROLONGED
EXPOSURE-NITRILE,IMPERVIOUS.
Eye Protection:SAFETY GLASSES OR GOGGLES RECOMMENDED.
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:AVOID EXCESSIVE BREATHING OF VAPOR.DON'T SPRAY
IN DIRECTION OF BODY.USE ONLY IAW DIRECTIONS.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

HCC:G2
Boiling Pt:=34.4C, 94.F
Vapor Pres:150SPIG CN
Vapor Density:APPROX 2.5
Spec Gravity:0.70
pH:NP
Viscosity:NP
Evaporation Rate & Reference:APROX 6, BUACETATE=1
Solubility in Water:APROX 6% @70F,MODERT
Appearance and Odor:PALE YELLOW TO CLEAR LIQ,STRONG ETHEREAL ODOR
Percent Volatiles by Volume:86.0
Corrosion Rate:NP

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:UNSTABLE EXPLOSIVE PEROXIDES MAY BE FORMED
AND CONCENTRATE BY EVAPORATION TO HAZARDOUS LEVELS. THIS PROCESS IS
FAVORED BY PROLONGED STORAGE WITH EXPOSURE TO AIR AND LIGHT.
Hazardous Decomposition Products:CARBON MONOXIDE MAY FORM ON
COMBUSTION.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DISPOSE OF IAW ALL LOCAL, STATE AND FEDERAL
REGULATIONS.DONT PUNCTURE OR INCINERATE.AVOID ANY CONTAMINATION OF
GROUNDWATER.

Transport Information:US DOT: ENGINE STARTING FLUID 2.1 UN1960 LABEL:
FLAMMABLE GAS

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.